Chevrolet 2006 impala Specifikace Strana 296

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 390
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 295
7. Remove the electrical connector from the bulb by
raising the lock tab and pulling the connector away
from the bulb’s base.
8. Install the electrical connector to the bulb.
9. Install the new bulb by inserting the smallest tab on
the bulb base into the matching notch in the
retaining ring. Turn the bulb a quarter-turn clockwise
until it stops.
10. Reverse Steps 1 through 5 to reinstall the headlamp
assembly.
When you reinstall the headlamp assembly, make
sure to line up the pin in the headlamp assembly
with the slot in the vehicle.
Taillamps, Turn Signal, Sidemarker,
Stoplamps and Back-up Lamps
A. Rear Sidemarker
B. Back-up Lamp
C. Stoplamp/Taillamp/Turn Signal
To replace one of these bulbs, do the following:
1. Open the trunk. See Trunk on page 2-13 for more
information.
2. Remove the convenience net, if your vehicle has
one. Unhook the net from the upper wing nut.
5-50
Zobrazit stránku 295
1 2 ... 291 292 293 294 295 296 297 298 299 300 301 ... 389 390

Komentáře k této Příručce

Žádné komentáře